Under the Bonnet (3000)

HIGH FLOW TWIN SU AIR FILTER

admin — Mon, 18 Feb 2008 12:47:43 +0000

A more modern design fitting directly to the carbs, which not only filters the air considerably better it does not loose any horsepower.

Our tests have shown a standard BJ8 to gain 6 BHP when using these over the original type.

TRIPLE WEBER AIR FILTERS

admin — Mon, 18 Feb 2008 12:47:43 +0000

High flow design, foam construction to make the most of the space constraints.

WEBER 45 DCOE CARBURETTORS

admin — Mon, 18 Feb 2008 12:47:43 +0000

These come jetted approximately for the 3000. We also carry a full range of jets & chokes etc.

Price stated is per item.

WIDER ACCELERATOR PEDAL

admin — Mon, 18 Feb 2008 12:47:43 +0000

This aluminium die casting bolts onto the existing throttle pedal and makes it wider which considerably helps when 'heel and toeing'.

Only fits 6 Cylinder.

TRIPLE S.U. INLET MANIFOLDS

admin — Mon, 18 Feb 2008 12:47:42 +0000

These manifolds will accept either 1.75"or can be opened out to suit 2" S.U. carbs. They come complete with stainless steel balance pipe and bracket for throttle operating rod.

Price stated is for a set.

WEBER FUEL RAIL

admin — Mon, 18 Feb 2008 12:47:43 +0000

Earls aluminium fittings ready assembled to suit triple Webers.

WEBER HEAT SHIELD KIT

admin — Mon, 18 Feb 2008 12:47:43 +0000

Aluminium plate with insulation spacer and screws to fit to the bottom of any side draft Weber carb. May require trimming around exhausts.

Please note: 1 kit required per carburettor

ITG DUST RETENTION FLUID

admin — Mon, 18 Feb 2008 12:47:43 +0000

Must be applied to all foam filters to achieve maximum performance.

UPSWEPT WEBER INLET MANIFOLDS

admin — Mon, 18 Feb 2008 12:47:42 +0000

Cast in aluminium, these manifolds are similar to the Works type, although running at approx 16 degrees and a little shorter, allows them to be used for left or right hand drive and gives a little extra power. They are designed not to need the support towers.

PLEASE NOTE: Modified pedal box (CBRK300W) should be used for LHD.

TRIPLE WEBER THROTTLE LINKAGE KIT

admin — Mon, 18 Feb 2008 12:47:42 +0000

This converts the car to twin throttle cables which is based on the Works design but with our improvements. It is complete except for the outer cable bracket at the pedal end (which must be fabricated yourself).

Suits LH & RH drive, upswept manifolds only.