![[]](/sites/bighealey.co.uk/modules/ecommerce/cart/images/cart_empty.png "View your cart items"){kind=spacer}
Under the Bonnet (3000)
HIGH FLOW TWIN SU AIR FILTER
A more modern design fitting directly to the carbs, which not only filters the air considerably better it does not loose any horsepower.
Our tests have shown a standard BJ8 to gain 6 BHP when using these over the original type.
TRIPLE WEBER AIR FILTERS
High flow design, foam construction to make the most of the space constraints.
WEBER 45 DCOE CARBURETTORS
These come jetted approximately for the 3000. We also carry a full range of jets & chokes etc.
Price stated is per item.
WIDER ACCELERATOR PEDAL
This aluminium die casting bolts onto the existing throttle pedal and makes it wider which considerably helps when 'heel and toeing'.
Only fits 6 Cylinder.
TRIPLE S.U. INLET MANIFOLDS
These manifolds will accept either 1.75"or can be opened out to suit 2" S.U. carbs. They come complete with stainless steel balance pipe and bracket for throttle operating rod.
Price stated is for a set.
WEBER HEAT SHIELD KIT
Aluminium plate with insulation spacer and screws to fit to the bottom of any side draft Weber carb. May require trimming around exhausts.
Please note: 1 kit required per carburettor
UPSWEPT WEBER INLET MANIFOLDS
Cast in aluminium, these manifolds are similar to the Works type, although running at approx 16 degrees and a little shorter, allows them to be used for left or right hand drive and gives a little extra power. They are designed not to need the support towers.
PLEASE NOTE: Modified pedal box (CBRK300W) should be used for LHD.
TRIPLE WEBER THROTTLE LINKAGE KIT
This converts the car to twin throttle cables which is based on the Works design but with our improvements. It is complete except for the outer cable bracket at the pedal end (which must be fabricated yourself).
Suits LH & RH drive, upswept manifolds only.